Transport; Storage; Hose From The Trigger Gun - Kärcher K 3 Manual Del Usuario

Foam nozzle
With powerful foam for effortless clean-
ing.

Fill the detergent solution in the de-
tergent tank of the foam nozzle (ob-
serve dosage instructions on the
packaging of the detergent).

Connect the detergent tank to the
foam nozzle.

Connect the foam nozzle to the trig-
ger gun.
Note: This will mix the detergent
with the water stream.
Interrupting operation

Release the lever on the trigger
gun.
Illustration

Lock the lever on the trigger gun.

During longer breaks (more than 5
minutes), also turn the appliance off
using the "0/OFF" switch.

Insert the trigger gun in its holder.
Finish operation
Caution
Only separate the high-pressure
hose from the trigger gun or the
appliance while there is no pres-
sure in the system.

After operation with detergent: Run
the machine for approximately 1
minute for a clear rinse.

Release the lever on the trigger
gun.

Turn off the appliance "0/OFF".

Turn off tap.

Press the lever on the trigger gun to
release any remaining pressure in
the system.
Illustration

Lock the lever on the trigger gun.

Detach the appliance from the wa-
ter supply.

Pull out the mains plug.
Caution
In order to prevent accidents or
injuries, keep in mind the weight
of the appliance during transport
(see Specifications).
When transporting by hand

Pull the appliance by its transport
handle.
When transporting in vehicles

Empty detergent tank.

Secure the appliance against shift-
ing and tipping over.
Caution
In order to prevent accidents or
injuries, keep in mind the weight
of the appliance when selecting
a storage location for it (see
Specifications).
Storing the Appliance
Prior to extended storage periods, as
during the winter, also observe the in-
structions in the Care section.

Park the machine on an even sur-
face.

Push the casing of the quick cou-
pling for the high pressure hose to-
ward the rear and disconnect the
high pressure hose from the appli-
ance.

Press the disconnect on the trigger
gun and remove the high pressure

hose from the trigger gun.


Insert the trigger gun in its holder.

Engage the spray lance in its com-
partment.

Stow away the mains cable, the
high-pressure hose and accessory
on the appliance.
EN
– 12

Transport

Storage

23