Lionelo Theo Manual De Usuario página 7

leg caps are non-slip, which prevents the baby bed from undesirable moving (fig. 7).
8. Attaching to a bed
The baby bed can be attached to a parents' bed. In order to do so, unzip
the side zippers completely, open the side of the baby bed and slide the rail
out of the mounts, as shown in the picture (fig. 8).
9.
Move the baby bed to a parents' bed and check the height of the baby bed
in relation to the parents' mattress.
10. Use the included belts to attach the baby bed to a parent's bed. Place the buckle
in the connector plug at the bottom of the gondola, run the belt from bottom
to top around the parents' bed construction, and then fasten the buckle.
The loop should be as tight as possible. You can adjust the length of the belt
with the clip in the middle. Repeat it for the other belts (fig. 9, 10).
CAUTION: Before each use, make sure there is no gap between the parents'
mattress and the side wall of the baby bed.
WARNING: The product can ONLY be attached to beds and/or mattresses with
straight sides. Do NOT use the product with round or water beds and/or mattresses.
WARNING: The maximum permissible inclination of the baby's bed is a difference
of 2 levels. The child's head must always be higher than other parts of the body
Maintenance
•
Clean the plastic parts with a soft cloth.
•
The mattress can be cleaned with a damp cloth and natural cleaners.
•
Do not use bleach to clean the product.
•
Do not iron.
•
Do not dry clean.
•
Do not tumble dry.
•
The fabric parts can be washed by hand (in up to 30ºC).
The product has been tested and meets all the requirements of the following
standards: EN 1130:2019+AC:2020, EN 16890:2017+A1:2021
The pictures in this manual are for illustrative purposes only. Therefore, they may differ
from the actual product.
‑ 7 ‑ EN