FONESTAR MSH-883 Manual De Usuario página 4

EN
HAND-HELD MICROPHONE (mod. MSHT-40M)
1.- Grille: for protecting the microphone capsule and helping to reduce breathing noises and the wind.
2.- Display: this shows information on the tuned frequency,such as the channel number, battery level, RF
signal level and audio signal. If the battery level is low, the display will light up red.
3.- Battery cover: unscrew this cover to get to the battery compartment.
4.- GAIN: the audio input sensitivity adjustment.
5.- q: on/off switch for the hand-held microphone.
6.- IR: wireless hand-held microphone infrared receiver. For tuning the receiver and the wireless hand-held
microphone, press the IR-SW button on the receiver and then place this IR receiver opposite the one
on the receiver.
7.- Battery compartment: use two 1.5 V LR6-AA type batteries, alkalines or rechargeable.When you insert
the batteries, make sure that the polarity is correct.
8.- SET: this button lets you select between the following setup options: channel number and frequency,
RF transmission level (high/low), battery type selection (1.2 V - rechargeable/1.5 V - alkaline) to show
the battery level correctly and the microphone transmitter lock. To do this, press the SET button con-
secutively and use the w/s buttons to select the options.
9.- w/s: for selecting menu options to set the hand-held wireless microphone.
10.- Contacts for recharging the rechargeable batteries in the wireless microphone in the recharge docking
station mod. MSC-2.
Note: when you press the SET button to setup the different microphone parameters, a MUTE indicator ap-
pears on the display and the microphone no transmits audio when the parameters are being set.
- 4 -