Assembly Of Iq-Xm Speed And Battery Pack - Busch+Müller Lumotec Serie Instrucciones De Uso

6.2. Assembly of IQ-XM speed and battery pack

Place the rubber ring
bar diameter, screw the locking screw and the locking knob
handlebar bracket
5
underneath the handlebar and fasten them using the locking screw
!
Please note: The locking knob
required)!
from the cyclist, use a screwdriver to unbolt the bracket on the underside of the headlight
180° and then fasten again. The bracket is the headlight
ring 6 .
The position of the headlight
the slant of the headlight
ment, the headlight
left or right. In both cases, the locking screw on the bracket must be loosened and securely re-tightened
afterwards once again to ensure that the headlight
Assembly of handlebar switch using a bracket
Suitable for handlebars of Ø 22 to 32 mm
Attach the handlebar switch
easily accessible to the handlebar using the enclosed rubber bracket
26
7 of the handlebar bracket
over the rubber ring
can be used either as a short or long version. (simply turn as
8
Short screw (30 mm)
Long screw (55 mm)
can be changed vertically and horizontally by a few degrees. Vertically,
1
is changed via the slant of the handlebar bracket
1
can be swivelled (to a limited extent) continuously on the rubber ring
1
to operate the headlight
3
5 around the handlebar. Depending on the handle-
8
with the locking knob
7
Insert the headlight
headlight bracket
5
firmly. It audibly engages in the locking ring
is firmly seated in place. To remove the headlight
locking ring clockwise, hold the headlight
6
pull it upwards. We do not assume any liability in case of drop
damage, e.g. because the headlight
while releasing the locking ring
on the bicycle only allows the locking knob
component that is screwed into the locking
1
1 cannot come loose or move all by itself.
and the high beam function securely and
1
into the handlebar bracket
facing the seat. Join the legs
8
.
8
vertically from above into the
1
in the direction of travel and press down
1 was not held in place
6 . If the assembly situation
. For horizontal adjust-
5
.
4
5 . Place the
6 . Make sure it
1 , turn the
firmly and
1
facing away
8
turn by
1
to the
7