Operation - Busch+Müller Lumotec Serie Instrucciones De Uso

Mounting the battery pack
Securely fasten the battery pack using the Velcro strap at a suitable position on the bicycle, or
alternatively, keep it safely elsewhere (e.g. in a bag or jersey). Connect the cables of the battery
pack and the headlight
2

7. Operation

Switch the headlight
approx. 2-3 seconds. When switched on, the last activated lighting mode of the low beam (high-,
mid- or low-power) is activated. To change the light mode, press the handlebar button
(approx. ½ second). The light mode then changes to the next higher level (low-mid-high-low...).
Repeat if necessary. If the battery level is low, the headlight
low-power mode.
When the low beam function is active, briefly press the handlebar switch
tivate the high beam function. The indicator lamp of the handlebar switch
the low beam function and blue for the high beam function.
When the high beam function is active, make sure to dim the beam in good time!
WARNING
Oncoming traffic must not be blinded.
If the residual capacity of the battery pack
can no longer be activated. To make the cyclist aware of this situation, the green LED in the
1
handlebar switch 3 briefly switches off every 10 seconds. The high beam function is automatical-
ly deactivated if active at that moment. Switching between the high-, mid-, and low-power mode
as well as using the headlight flasher are still possible.
If the battery level continues to decrease, only operation in the low-power mode is possible, and
the battery pack must be recharged.
2
CAUTION: As soon as the green + blue LEDs in the handlebar switch
lighting values are no longer fulfilled. In the course of the next 60 minutes, the headlight
dually becomes darker and darker until it switches off completely (Safe-Way-Home-Function).
This is a safety precaution to prevent depth discharge of the battery pack
in severe falls or accidents. Therefore, always adjust your behaviour and speed to the available
light and interrupt the ride in time. Never ride in insufficient brightness without adequate light.
.
1
(low beam) on and off by keeping the handlebar switch
1
1 automatically switches to the
is low, the high beam function of the headlight
2
pressed for
3
briefly
3
to activate or deac-
3
3 lights up green for
3 are flashing together, the
1
2 which might result
gra-
27