Tensai 150 Manual De Instrucciones página 17

Standard layout
In the following drawings you will find an example of a
rack arrangement that will permit you, with the shelves
supplied and the
(EN62552:2013), achieve the declared capacity of your
cellar.
Model 150 (A)
Capacity - 138 Bottles
2 Fixed shelves
1 Sliding shelf
1 Selection drawer
Inserting a rack fixed shelf
Note: pay attention to positioning to the right or left of
the supports.
Align rack clips with the desired wall fittings, press the
back of the rack (A) down in order to completely fit the
clip in the slot. Repeat in the front clip (B).
Make sure the rack is completely secure to side wall.
Removing fixed racks
(B)
Pull up front rack until the clip is loose from the side
wall, repeat on the back of the rack
Installing fixed shelves
Make sure the racks have the vibration dampers installed
(C), put the shelf above the dampers, slide it back so that
it fits and cannot move forward.
Inserting a sliding shelf rack
Align the back clip with the desired wall fitting, push
back in order to completely fit the clip in the slot (F).
Align the front clip with the slot pressing it down in order
to completely fit the clip in the slot (G).
SHELVES LAYOUT
standard bottle dimension
Capacity - 237 Bottles
1 Selection drawer
(pag.39 / IMG 4)
(A)
.
(pag.39 / IMG 5)
(pag.39 / IMG 6)
Alternative layout
You can also buy additional shelves from your retailer
and increase the flexibility of your appliance. Here you
have some exemples.
Model 190 (B)
3 Fixed shelves
2 Sliding shelf
Make sure the rack is completely secure to the side wall.
Removing sliding shelf racks
Pull up the front rack until (G) the clip is lose from the
side wall, pull back clip out (F) of the slot in your
direction.
Inserting a sliding shelf
Insert the sliding shelf above the rack rollers (1º),
allowing it to slide into the guides (2º).
Inserting a "Selection" drawer rack
IMG 8)
Note: pay attention to positioning to the right or left of
the supports.
Align the back clip with the desired wall fitting, push
back in order to completely fit the clip in the slot (H).
Align the front clip with the slot, pressing it down in order
to completely fit the clip in the slot (I). Make sure that the
rack is completely secure to the side wall.
Inserting a drawer in the rails
Position the drawer above the rails and push it.
17
Model 190 side by side (C)
Capacity - 237+237 Bottles
3+3 fFxed shelves
2+2 Sliding shelf
1+1 Selection drawer
F- Fixed | T- Drawer | C- Sliding
(pag.39 / IMG 7)
(pag.39 /
(pag.39 / IMG 9)