Safety Instructions And Precautions - Kinderkraft RACOON Manual Del Usuario

SAFETY INSTRUCTIONS AND PRECAUTIONS

WARNINGS
•
Remember about the risks related to open flames and other strong heat
sources, such as radiators/electric or gas heaters etc. near the product.
•
Do not place the toy box near heat sources, windows.
•
Do not use the product if any of its parts is damaged or missing, use only original
manufacturer parts.
•
All assembly parts and frame shall be well tightened during the assembly and
regularly checked and tightened if necessary.
•
Do not leave children alone so that they do not enter inside the box.
•
The product is not a toy. The box is intended only for storage.
•
Maximum load of the box is 20 kg
1. List of parts - page 4
2. Assembly of the toy box:
I. Tools: Philips and flat-blade screwdriver. Do the assembly on a soft floor that will not damage
the surface of the parts.
Begin assembly by placing four wheels (C) of the box flat on the outer side. Then push the studs
6x20 mm (4) into designated places (opening in the middle of the inner side of the wheels). Put
the side walls of the box (A and B) flat with the outer side towards the floor. Put the side walls
of the box to the studs in the wheels so they fit into the openings. Then tighten two screws (1)
for each wheel.
II. Lay the front (E) and back (D) wall of the box with the outer side towards the floor. Carefully
press the studs into the sides (D and E) in the designated places. Then insert the connectors (2),
two for each wall of the box (D and E), into correct openings so the side bushings in the
connectors match the openings in the sides of the walls. Put the front wall (E) perpendicular to
the side wall (A). Connect with studs 6x25 mm (5) and tighten with screws (3). Repeat with the
back wall (D).
III. To the construction from the second step, slide the bottom of the box (F) along the
designated grooves.
IV. As in the second step, place the other studs 6x25 mm (5) in the sides of the front and back
walls (D and E) in the designated places. Then insert the connectors (2), two for each wall of the
box (D and E), into correct openings so the side bushings in the connectors match the openings
in the sides of the walls. Carefully install the side wall of the box (B) with the other elements,
guided by the position of the studs. Then tighten the side wall (3) to the construction. Check all
screw connections to make sure that the box is correctly assembled and is safe for children.
3. Maintenance and cleaning
Clean with a soft, clean and dry cloth.
14