Custom Functions; Replacing The Flash Tube - Phottix Indra500 TTL Manual De Instrucciones

Custom Functions

The Phottix Indra500 TTL Studio Light comes with a number of programmable
custom functions. To edit these functions (see below):
1. Press and hold Function button 4 and the "Adjust/Set knob" for 3 seconds to
enter the C.Fn Menu Screen.
Custom Functions Chart

Replacing the flash tube

1. Disconnect the Indra500 TTL Studio light from a power source for 10 minutes
before changing the flash tube.
2. Remove the Reflector as shown above.
3. Gently separate the Glass Dome from the snap mount, remove the Glass
Dome. (Picture 9)
4. Gently hold the flash tube to remove it from the snap slot. (Picture 10)
12
INSTRUCTION MANUAL
En
2. Press Function button 1 or Function button 2 to cycle through the menu
items – C.Fn 00 to 03.
3. Turn the "Adjust/Set knob" to change the functions within the menu.
4. Press Function button 4 to exit the C.Fn menu.
5. Insert a new flash tube into the snap slot. (Picture 11)
6. Mount the Glass Dome align the snap mount. (Picture 12)
7. Attach the Reflector as shown above.
Note: Please wear gloves instead of touching the flash tube directly when re-
placing the flash tube.