Shredder/Slicer Assembly - Weston 82-0103-W Manual Del Usuario

SHREDDER/SLICER ASSEMBLY

NOTE: The Shredder/Slicer Attachment cannot be used with meat products.
1. Loosen the Head Locking Knob on the side of the Motor Unit.
2. Install the Shredder/Slicer Head onto the Motor Unit (FIGURE 5).
3. Tighten the Head Locking Knob to secure the Shredder/Slicer Head in place.
4. Insert a Blade into the Shredder/Slicer Head until it is fully seated. The open
end of the Blade should face outward. Make sure the notches in the Blade mesh
with the splines on the drive shaft within the cavity of the Head.
5. Insert the Blade Retaining Pin into the hole in the front, upper-right corner of the
Shredder/Slicer Head. The longer leg of the Retaining Pin goes on the inside of
the Blade.
Shredder/Slicer
Stomper
Shred-
Slicer Head
Blade
Retaining
Pin
Blade
All manuals and user guides at all-guides.com
der/
FIGURE 5
Head
Locking
Knob
Motor
Unit
11