Assembly - Flymo PowerVac 3000 Instrucciones De Empleo

3. Assembly

WARNING:
inlet cover or attempting to install or remove the blower tube or vacuum tubes.
The motor must be stopped and the impeller blades no longer turning to avoid
serious injury from the rotating blades.
Fitting the blower tube:
2
Fitting the vacuum tubes:
8 4
7
9
0
20
9667594-01_9667594-62 PowerVac 3000 3000-20.960.01.indd 20
All manuals and user guides at all-guides.com
Stop the unit and unplug the extension cord before opening the
1. Align the grooves on the blower tube
blower outlet
3 1
2. Push the blower tube onto the blower outlet until it snaps into
place; tube is secured to blower by tube release button
3. To remove the blower tube, press the tube release button
while pulling on tube.
NOTE: A safety switch will prevent the unit from starting if the
blower tube is not installed correctly.
5
1. Open the inlet cover
and pulling up on the vacuum assist handle
6
2. Allow latch to snap into rear handle of blower
Ensure mains cable
NOTE: There are 2 vacuum tubes, an upper tube
tube .
0
The upper tube has a hinge and hooks on one end and is cut
straight on both ends. The upper tube attaches to the blower unit.
The lower tube has a curved end that you point toward the ground
during vacuum use. The lower tube attaches to the upper tube.
3. To attach the lower vacuum tube
tube , first align the seams of the two tubes.
9
Then, press the two tubes together until the lower tube is
fully seated in the upper tube.
1
.
2
by releasing the latch
4
remains free.
8
to the upper vacuum
0
with the grooves on the
.
3
3
as shown
5
.
6
.
7
and a lower
9
19.06.15 12:38