Troubleshooting - Flymo PowerVac 3000 Instrucciones De Empleo

Aspirador/soplador de jardin
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 115
WARNING:
extension cord. Wait until the impeller has completely stopped turning,
then remove the vacuum tubes. Carefully reach into the vacuum opening
and clear out the clogged debris.
This will reduce possible personal injury from the impeller.
Removing an object from the
air intake:

7. Troubleshooting

WARNING:
performing all of the recommended remedies below except remedies
that require unit to be operating.
The motor must be stopped and the impeller blades no longer turning to
avoid serious injury from the rotating blades.
Problem
Unit fails to operate.
Unit vibrates abnormally.
Impeller will not
turn freely.
For any other malfunctions, please contact the Flymo
service department. Repairs must be carried out by Flymo
service departments or specialist dealers authorised by
Flymo.
26
9667594-01_9667594-62 PowerVac 3000 3000-20.960.01.indd 26
All manuals and user guides at all-guides.com
If the unit becomes clogged, stop the unit and unplug the
1. Remove the vacuum tubes.
2. Carefully reach into the vacuum opening and clear out the air
intake area. Clear all debris from impeller.
3. Inspect the impeller for cracks. If cracked or damaged,
do not use the unit. Have parts replaced by your authorized
service dealer. Do not attempt to replace them yourself.
Always stop unit and unplug the extension cord before
Possible cause
1. Switch in the OFF (0) position.
2. Extension cord disconnected.
3. Circuit breaker tripped,
or fuse blown.
4. Blower tube, elbow tube,
and/or vacuum tube not
installed correctly.
5. Collection bag is full.
6. Mechanical failure.
1. Mechanical failure.
1. Debris in air intake area.
2. Mechanical failure.
Remedy
1. Slide switch to
ON (I) position.
2. Reconnect extension cord.
3. Reset circuit breaker or
fuse.
4.Check tube installation.
5. Empty collection bag.
6. Contact your authorized
service dealer.
1. Contact your authorized
service dealer.
1. Clean unit. Remove any
debris.
2. Contact your authorized
service dealer.
19.06.15 12:38

Publicidad

Tabla de contenido
loading

Tabla de contenido