Attach The Carrying Ring; Use The Shoulder Strap; Preparation For Cutting; Operation - Cramer A48T10PS-CR Manual Del Usuario

If the button does not release completely in the positioning
hole, the shafts are not locked into place. Slightly rotate
from side to side until the button is locked into place.
3.4

ATTACH THE CARRYING RING

Figure 4.
1. Pull carrying ring apart and place over power head end of
shaft; position near the power head.
2. Install bolt and lock nut.
3. Tighten nut securely.
Check for tightness before each use to avoid serious injury
or product damage.
3.5

USE THE SHOULDER STRAP

Figure 5.
1. Attach the carabiner to the carrying ring on the pole.
2. Put on the shoulder strap.
3. Adjust the length of the strap so that the carabiner is
about the width of a hand below your right hip.
3.6

PREPARATION FOR CUTTING

Figure 5.
• Wear non-slip gloves for maximum grip and protection.
• Maintain a proper grip on the unit whenever the motor is
running. Use your right hand to firmly grip the rear
handle while your left hand has a firm grip on the pole
shaft.
• Hold unit firmly with both hands. Always keep your left
hand on the pole shaft and your right hand on the rear
handle, so your body is to the left of the chain line. Never
use a left-handed (cross handed) grip, or any stance that
places your body or arm across the chain line.
• Never stand directly under the limb you are cutting.
• Be certain the collars are fully tightened before operating
equipment; check them periodically for tightness during
use to avoid serious injury.
4

OPERATION

Remove the battery pack and keep hands clear of the lock
out button when you move the machine.
IMPORTANT
Examine the chain tension before each use.
NOTE
NOTE
NOTE
English
4.1

DELIMBING A TREE

Figure 6.
Make sure that there is nothing or nobody in the area where
the branches fall.
• Stand opposite the branch you will cut.
• Start to cut the higher branches.
• Then cut the lower branches.
• Cut downwards to prevent the bar from jamming.
5

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
5.1 ASSEMBLE THE GUIDE BAR AND
THE CHAIN
Figure 8-13.
1. Remove the battery pack from the machine.
2. Remove the chain cover nuts with the wrench.
3. Remove the chain cover.
4. Put the chain drive links into the bar groove.
5. Put the chain cutters in the direction of the chain
operation.
6. Put the chain in position and make sure that the loop is
behind the guide bar.
7. Hold the chain and bar.
8. Put the chain loop around the sprocket.
9. Make sure the chain tension pin hole on the guide bar fits
correctly with the bolt.
10. Install the chain cover.
11. Tighten the chain. Refer to Adjust the chain tension.
12. Tighten the nuts when the chain is well tensioned.
If you start the chain saw with a new chain, have a test for
2-3 minutes. After that, examine the tension again and
tighten the chain if necessary.
5
WARNING
CAUTION
CAUTION
WARNING
NOTE
EN