Remove The Bit; Operation; Start The Machine; Stop The Machine - GreenWorks DD24L00 Manual Del Operador

EN
Do not use a wrench to tighten or loosen the chuck.
Put the bit straight into the chuck jaws. Do not put the bit
into the chuck jaws at an angle then tighten.
7.5

REMOVE THE BIT

1. Push forward / reverse switch in "neutral" position to lock
the trigger.
2. Turn the chuck counter-clockwise to open.
3. Remove the bit.
Be prepared for binding at bit breakthrough. When these
situations occur, drill has a tendency to grab and kick
opposite to the direction of rotation and could cause loss of
control when breaking through material. If not prepared,
this loss of control can result in possible serious injury.
8

OPERATION

Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
8.1

START THE MACHINE

The machine can not work until the forward / reverse switch
is pushed fully to the left or right. Do not operate the
machine at low speeds for extended periods of time.
1. Pull the trigger to turn the drill ON.
Variable speed
The machine has a variable speed switch that delivers higher
speed with increased trigger pressure and lower speed with
decreased trigger pressure.
NOTE
WARNING
WARNING
WARNING
WARNING
NOTE
English
8.2

STOP THE MACHINE

1. Release the trigger to turn the machine OFF.
Release the trigger and allow the machine to come to a
complete stop.
8.3

LED LIGHT

4
The LED light illuminates when the trigger is depressed.
It provides extra light for increased visibility.
8.4

TWO-SPEED SWITCH

The machine has a two-speed switch designed for drilling or
driving at LO (1) or HI (2) speeds. A slide switch is on top of
the machine.
1. When you use the machine in the LO (1) speed, the speed
decreases and the machine has more power and torque.
2. When you use the machine in the HI (2) speed, the speed
increases and the machine has less power and torque.
Use LO (1) speed for high power and torque applications
and HI (2) speed for fast drilling or driving applications.
8.5

FORWARD / REVERSE SWITCH

The machine has the switch (forward / reverse) above the
trigger to change rotation.
8
WARNING
WARNING