Maintenance And Cleaning; Greasing Of The Blades - Kamikaze KV 362 Manual De Uso

ELECTRIC PRUNING SHEARS
14.2. OPENING CHANGE (ONLY IN PROGRESSIVE MODE)
The KV362 machine incorporates a memory blade opening change system.
This means that we can always adjust the opening of the blade according to
the appropriate cutting diameter.
The opening of the blades can be adjusted in two positions:
• 100% blade opening (default start opening).
• 50% blade opening approximately.
Procedure to adjust the opening of the blades:
• Press the on/off button. After the beep, press the trigger twice within one
second to open the blade - 100% blade opening.
• Press the power button once. After the beep, pull the trigger all the way
down and you will hear another beep indicating that you have changed the
aperture to 50%.
• Press the power button. After a beep, pull the trigger all the way and the
blade opening will return to 100%.

15. MAINTENANCE AND CLEANING

Tools to be repaired must be sent to Customer Assistance Service.
Use original part keeps the tool good condition and safe.
Disconnect the battery from the tool before checking, maintaining
and repairing the pruning shear, to avoid risk of unexpected
activation of the tool.
Warning!
In particular situations of very hard use, the blade and the handle could reach
high temperatures. It is recommended to handle the pruner with care, using
protective gloves.
Please wear glove before you check the blade is sharp or not, that
is to avoid blade hurt you.
www.kamikazevolpi.com
48
ELECTRIC PRUNING SHEARS
Check the pruning shear frequently, this will keep tool safe and reliable.
• Do not flush the tools or put it in water, it will cause short circuit or
damage the device.
• Keep ventilation, motor and handle cleaning, always use feather clean the
device. Do not use cleanser flush device, it will rust parts.
• Clean the blade after every use, protect by oil or spray protection.
• After continuous work for 8 hours, please open the trigger cover
protection of the equipment and clean up wood chips and other
impurities.
15.1. SHARPENING
• Sharpening is very important to keep blade in good condition and ensure
long life.
• The tool have attached accessory to sharp blade.
• Always check blade is in good condition before to start work. Of course,
the frequency of sharpening depends on the nature of the sheared wood
(hardness and diameter), pruning rate and sharpening tools (special
abrasive tools are provided). As a result, the blade must be checked
frequently during the initial period of use to determine the appropriate
grinding time (check every 15 minutes and you will quickly calculate)
• Adjust the clearance of the moving blade to ensure that the cut is clean
and accurate. The gap between the blades should be checked regularly
as friction wears the blades where they come into contact. The nut is
designed to block its position with the central screw which allows
adjustments if needed.
• To adjust the blade to the appropriate distance of about 0.03 mm loosen
the central screw of the nut by turning it clockwise, turn the nut clockwise
to reduce the clearance and counterclockwise to increase the clearance.
When the adjustment is complete, hold the nut locked in place and tighten
the central screw by turning it counterclockwise

15.2. GREASING OF THE BLADES

The greasing of the blades has sto be repeated each 2-3 working days to
guarantee the correct performance of the tool and to avoid the seize of
the blades.
www.kamikazevolpi.com
49