INFOSEC UPS SYSTEM Zenergy Station 2000 Manual Del Usuario página 8

Follow the charts below to replace the batteries:
Step1:
Switch-off the station and disconnect it
from the mains power.
Remove the screws located on the
bottom of the Zenergy Station to open
the battery cover.
Step2:
After removing the battery cover, gently
extract the battery from the case.
Step 3:
Disconnect the two wires linked to the
Zenergy Station and replace the battery
by the same type. (Red: + / Black: –)
Dispose of the old battery properly at an
appropriate recycling facility.
9 . T R O U B L E S H O O T I N G
Should the Zenergy Station fail to function correctly we recommend you to perform the
following tests before calling the Hot Line.
Symptom
Orange led lights up and
audible alarm is heard
intermittently.
Zenergy Station is
functioning but the
audible alarm is heard
continuously or twice a
second.
1 0 . I N S U R A N C E F O R C O N N E C T E D E Q U I P M E N T
The equipment connected to the Zenergy Station benefits from a free insurance up to
120.000 €. To get further information and register, please visit the Infosec web site.
8 INFOSEC UPS SYSTEM - 4, rue de la Rigotière – 44700 Orvault – FRANCE - www.infosec.fr
Hot Line : tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr - 10 04 04 206 13
All manuals and user guides at all-guides.com
Possible cause
Zenergy Station is not
connected properly to
the mains power.
Overload of the Zenergy
Station.
Solution
Properly connect the
Zenergy Station according
to the installation section
of this user guide.
Check that the load
matches the Zenergy
Station capacity
specified in the technical
specifications of this user
guide.