Technical Data Charger And Battery (D); Function Of The Unit; Overview (A); Changing The Battery (B-1) - Rothenberger ROBEND 4000 E Instrucciones De Uso

3 Technical Data charger and battery
Battery:
U = Voltage
C = Capacity
W = Weight
Ic = Charge current
t = Approx. charging time (90% full)
Charging voltage.............................
Charging temperature .. 0° - 50° C, 32° - 122° F
Max. discharging
temperature. ................................
Recharge battery pack before first use!
4

Function of the Unit

Capacity: Hard and soft Cu-Al DIN 1786, DIN EN 1057/ 12735-1/ 13348 Øs 12 a 35 mm: 1,2
mm pared, Hard and soft steel DIN 2391, DIN 2393, DIN 2394; Øs 12 a 28 mm x 2,5, Steel DIN
2440 1/4" (14), 3/8" (18), 1/2 " (22), 3/4 " (28), INOX AISI 304-316 espesor hasta 1,5 mm Øs 12
a 28 mm.
4.1 Overview
Battery
1
Reverse lever
2
Handle
3
Bolt housing
4
Tripod
5
4.2 Changing the battery
Slide the battery in until you hear it lock into place. Remove the battery by pressing down on the
lock and then pulling the battery out.
Using a battery with at least 4.0Ah is recommended to ensure the optimum processing of pipes
with large diameters. Otherwise, the device's power might be insufficient and the device will
switch off during the operating cycle.
4.3 Commissioning
The unit provides a device for setting the bending angle automatically from 0º to 180º.
 Loosen the graduated scale surrounding the former shaft and align the desired angle.
The machine is now set up and ready for use.
4.4 Operation
For all bending applications, carefully follow the steps described!
 Select the tube or pipe to be bent. Choose the relevant bending former and shoe suited to
the tubes size.
 Ensure that the ROBEND 4000 E is set in the start position by starting the motor with the di-
rection lever in the reserve position until it triggers off and moves to the neutral position.
 Place the bending former onto the centrepin. Lay the tube into the bending former and se-
cure it into the hook.
Ensure that the tubes is fully inserted into the hook and has contact with the whole
hook surface.
18
20,75 V DC
5° - 50° C, 41° - 122° F
ENGLISH
Charger:
U1 = Input voltage
f1 = Input frequency
P1 = Input power
U2 = Charging voltage
I2 = Max. charge current
Nc = No. of battery cells
W = Weight
Pay attention to the electrical outlet
voltage! Check the label on the
bottom of the charger!
Former
6
Former fastening shaft
8
Slide
9
Slide fastening bolt
10
Series bending scale
11
(D)
(A)
(B-1)
(B-2)
(C)