Technical Data Battery / Charger; Function Of The Unit; Changing The Battery A; Emergency Stop Button B-1 - Rothenberger ROMAX 3000 Instrucciones De Uso

2.1

Technical data battery / charger

Battery:
Type ............................................ ROMAX Li-Ion
Voltage ........................................ 18 V
Capacity ...................................... 3,0 Ah
Approx. charging time (90% full) ..........................................
Recharge battery pack before first use!
3

Function of the Unit

3.1 Changing the battery
Insert battery until the catch clicks into place. (LED flashes briefly = Contact made). To remove
press the catch and take out the battery.
If the battery voltage is lower than necessary, the LED flashes red. Charge the battery in
the charger.
3.2 EMERGENCY STOP Button
If there is any danger to personnel or the machine during the pressing process, press the
EMERGENCY STOP button immediately and release the ON switch. The valve will open and
the piston will return to its initial position.
3.3 To switch on
Press lightly the ON button, white LED's lights up for 30 sec.
Press the ON button until the pressing process has been completed. The motor cut out indicates
the end of the moulding cycle.
3.4 To turn the press jaw
The press jaw can be turned through 270° depending on the application.
3.5 LED
The red LED can indicate the following:
Flashes red: Battery is flat. The current press process will be ended automatically. The ON but-
ton will then be disabled and a new cycle can only be started once the battery has been
charged.
Lights up red: After 20.000 press cycles the LED lights up red after each moulding cycle to in-
dicate that the next inspection is due. An internal counter keeps a record of the number of press-
ing since leaving the factory.
The white LED's lights up by starting the press cycle (up to 30 sec. after end of the press cycle).
3.6 To insert the press jaw
Remove battery!
 Open the bolt (1).
 Insert the appropriate press jaw for the job in hand (2).
 Lock the bolt (3).
After changing the press jaw it is essential to ensure that, once engaged, the crimping jaw
matches the profile being moulded and the nominal width of the fitting being moulded. A visual
inspection must be carried out in order to determine that the press jaw is fully closed at the end
of the press cycle.
16
Charger:
Mains voltage. ................. 90 – 240 V
Mains frequency ............. 50 – 60 Hz
Max. output ..................... 58 W
ca. 85 min Voltage range ................. 18 V
Weight ............................ ca. 675 g
ENGLISH
Pay attention to the mains voltage!
Check the label on the bottom of the
charger!
A
B-1
B-2
B-3
C
D