FONESTAR ACADEMY-1 Manual De Usuario página 4

VOLUME
OFF
MIC
OUT
EN ON
5 V DC
OFF
INSTRUCTIONS FOR USE
ON
5 V DC
6 7 8 9 10
TRANSMITTER - RECEIVER LINKAGE
8 9 10
- This system has 2 linking modes radio frequency (RF) or infrared (IR).
- RF: both devices are linked in a close range.
- IR: both devices are linked by facing the IR sensors of both devices.
The linking mode on the receiver is set by the RF/IR button on the rear panel. Press for RF and do not press IR.
The pairing mode on the transmitter is set by long presses of the buttons
a
P
b
press of this button combination will change the mode on the display with all options shown:
c
UHF U L IR PPT
: RF linking mode.
-
_
d
64
e CH
U L IR PPT
- : IR linking mode.
_
14
f
NOTA: It is recommended to turn the transmitter off and on again after changing the pairing mode.
g
IR LINKING
1.- Select the IR linking mode on both transmitter and receiver. The pairing status indicators on both
devices will flash. Reset the transmitter if necessary.
2.- Place the transmitter and receiver IR sensors within a few centimetres and facing each other without
any obstructions. When the pairing status indicators change to solid, this indicates successful pairing.
RF LINKING
1.- Select RF linking mode on receiver and UHF on transmitter. Reset the transmitter if necessary.
2.- Place the transmitter at a distance of approximately 1 metre. When the pairing status indicators stay on,
this indicates successful pairing.
OTHER SETTINGS ON THE TRANSMITTER
1.- With the transmitter switched on, press the buttons + and -. By means of the + and - you can navigate
through the menu options and with the
screen.
2.- The following options are available:
- Maximum volume limiter: OFF, 1 (-10%), 2 (-20%) and 3 (-30%).
- Simple equalisation: BAS (BASS, low frequencies), L-M (low-mid frequencies), BAL (all frequencies),
H-M (high-mid frequencies) and TRE (TREBLE, high frequencies). EQ allows you to boost frequencies
within a selected band (low, low-mid, high-mid, high) or all bands equally (BAL).
- Receiver signal level: 00-07.
- Transmitter signal level: 00-07.
3.- Press the button
CONNECTION
- Check the battery charge status of the transmitter.
- Connect the receiver's MIC OUT output to an amplifier or mixing console with the microphone output
volume control set to minimum.
- If you are using the PC control, connect the LINK port to the PC using the microUSB to USB cable. Switch
on the devices and pair the transmitter and receiver.
- Finally, adjust the volume of the MIC OUT output and the transmitter itself.
or wait to exit the menu.
button modify the values of the option being displayed on the
- 4 -
and simultaneously, each