Installation Instructions; Front Vent; Leveling Instructions - Danby Silhouette Professional DIM32D1BSSPR Manual Del Propietário

Ocultar thumbs Ver también para Silhouette Professional DIM32D1BSSPR:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS

LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled (garages, porches, vehicles, etc.).
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 15 inches (38 cm) wide by
34.3 inches (87 cm) high by 24.2 inches (61.4
cm) deep.
• The ice maker should be placed in an area
where the ambient temperature is between 54°F
- 95°F (12°C - 35°C). If the ambient temperature
is above or below this range the performance of
the appliance may be affected.

FRONT VENT

This appliance is front breathing. Do not block the
front air vent as this will result in high operating
temperatures, higher energy usage and possible
system overheating and failure.

LEVELING INSTRUCTIONS

There is an adjustable leg on the bottom of the
appliance that can be turned up or down to ensure
that the appliance is level. It is important that the
appliance is level to minimize noise and vibration.
To level the appliance:
1. Move the appliance to its fi nal location.
2. Turn the leveling leg counter-clockwise as far as
it will go, until the top of the foot is touching the
bottom of the chassis.
3. Slowly turn the leveling leg clockwise until the
appliance is level.
3

Publicidad

Tabla de contenido
loading

Tabla de contenido