Marathon ULTRAWIDE CL030079 Manual De Usuario página 10

NOTE: signal reception is normally better at night and when the weather is
clear. The atomic WWVB signal generally takes a few hours to synchronize.
It is important to set the clock with the correct time zone and turn daylight
savings time on or off, according to where you live to ensure an accurate
time reading after successful WWVB signal reception.
Setting up the clock manually
When the clock is searching for the WWVB signal (
can press and hold
and then set the clock manually by holding the
Set Time Zone
Button control
Press once
Set Clock
Button control
Press and hold for 3 seconds
button to stop the reception (
+ /
Press 1x = SET TIME ZONE
PACIFIC will flash. Press
desired time zone
Pacific (Default) / Mountain / Central
/ Eastern / Atlantic / Samoa / Hawaii /
Alaska
To enter setup mode.
•
Press and hold the
•
seconds,
Once DST is flashing, press the
•
button again to customize the
following:
Press 0x = SET DST
(DAYLIGHT-SAVING TIME)
Once DST is flashing, press
to select DST ON or OFF depending
on if you live in an area where DST is
observable or not.
icon is flashing), you
icon disappears)
SET / .
Steps
button to select
–
Steps
button for 3
SET
or button
+ –
SET