Power Supply; Cutting Capacity; Standard Equipment - Stanley STEL701 Manual De Instrucciones

20 • ENGLISH
f Avoid prolonged contact with dust from power
sanding, sawing, grinding, drilling, and other
construction activities. Wear protective clothing
and wash exposed areas with soap and water.
Allowing dust to get into your mouth, eyes, or lay on
the skin may promote absorption of harmful chemicals.
Warning! Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust exposure.
Direct particles away from face and body.For your
convenience and safety, the following warnings are on
your Heavy-Duty 14" (355mm) Chop Saw:
For safe operation read the instruction manual.
f Do not use toothed blades.
f Use only reinforced wheels rated 4100 rpm or
higher.
f When servicing use only identical replacement
parts.
f Always: wear eye protection, use guards, clamp
work in vise, use proper respiratory protection.
f Do not expose to rain or use in damp locations.
f Only use chop saw wheel of a max. Thickness of
2.8mm and a max. Diameter of 355mm.
FEATURES (Fig. A)
1. Spark deflector screw
2. Spark deflector
3. Base
4. Fence
5. Vise
6. Flat Wrench
7. Crank
8. Vise Lever
9. Wheel
10. Guard
11. Spindle Lock
12. Depth Stop Bolt and Jam Nut
13. Trigger Switch
14. Padlock Hole

POWER SUPPLY

Be sure your power supply agrees with the nameplate
marking. A voltage decrease of more than 10% will cause
a loss of power and overheating.

Cutting capacity

The wide vise opening and high pivot point provide cutting
capacity for many large pieces. Use the cutting capacity
chart to determine total maximum size of cuts that can be
made with a new wheel.
Caution! Certain large, circular or irregularly shaped
objects may require additional holding means if they
cannot be held securely in vise.
Caution! Do not cut magnesium with this tool.
Maximum cutting capacity
Note: Capacity shown on chart assumes no wheel wear
and optimum fence position.
Workpiece 90° Cutting
Shape Angle
4-1/2" x 5-1/8"
A x B
USE

Standard equipment

1 14" Metal cutting abrasive wheel
1 Wheel wrench
1 Instruction manual
To carry (Fig. A)
Fold down unit to position where you can carry the saw.
Hook lock chain (24) to lock arm down.
Unlocking (Fig. A)
To unlock tool and raise head, depress motor arm slightly and
unhook lock chain (24) out. Motor arm will then pivot upward.
Depth stop (Fig. A)
Depth stop is set at the factory for a new 14" wheel to
prevent wheel from cutting into the supporting surface.
To allow more depth of cut, use the flat wrench provided
(7) to loosen the depth stop bolt (13) and raise bolt to
desired height and then turn jam nut (13) clockwise until
seated firmly on the casting. Securely tighten the depth
stop bolt before use.
45° Cutting
Angle
A = 4-7/8" A= 4-1/2"
(125mm) (115mm)
A = 4-1/2" A = 3-13/16"
(115mm) (98mm)
(115mm x
130mm)
4-1/2" x 3-13/16"
4" x 7-5/8"
4-1/8" x 3-3/4"
(102mm x
(105mm x
188mm)
95mm)
3" x 7-3/8"
(76mm x
229mm)
A = 4-1/2" x
A = 3-13/16"
5-3/8"
3-3/4"
(115mm x
(95mm)
137mm)