Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLE! TOOL WILL NOT START
WHAT'S WRONG?
Tool not plugged in.
Fuse blown or circuit breaker tripped.
Cord damaged.
Brushes worn out.
TROUBLE! TOOL MAKES UNSATISFACTORY CUTS
WHAT'S WRONG?
Glazed wheel.
Workpiece incorrectly placed or clamped.
TROUBLE! BLADE DOES NOT COME UP TO SPEED
WHAT'S WRONG?
Extension cord too light or too long.
Low voltage.
Low generator voltage.
TROUBLE! TOOL VIBRATES EXCESSIVELY DURING CUT
WHAT'S WRONG?
Damaged wheel.
Workpiece not clamped properly.
TROUBLE! DOES NOT MAKE ACCURATE CUTS
WHAT'S WRONG?
Fence not adjusted correctly.
Wheel is not square to fence.
Excessive force used to make cut.
Work piece moving.
TROUBLE! MATERIAL MOVES DURING CUT
WHAT'S WRONG?
Fence slipping or workpiece incorrectly placed or
clamped.
Vise too loose
Excessive cutting force.
TROUBLESHOOTING
WHAT TO DO...
Plug in saw.
Replace fuse or reset circuit breaker.
Have cord replaced by authorized service center.
Replace brushes.
WHAT TO DO...
Dress the wheel or replace with a new one.
Firmly clamp and support workpiece.
WHAT TO DO...
Replace with adequate size cord.
Contact your electric company.
Check generator output voltage. Reduce number of tools
powered by the generator.
WHAT TO DO...
Replace wheel.
Refer to Material Clamping and Supporting page 21.
WHAT TO DO...
Check and adjust. See Fence Operation on page 21.
Check and adjust.
Reduce cutting force, let the wheel do the work.
Clamp workpiece securely. See Material Clamping
and Supporting, page 21. Make sure material is
laying flat against the base.
WHAT TO DO...
See Material Clamping and Supporting, page 21.
Tighten vise clamping.
Reduce cutting force.
ENGLISH • 23
Publicidad
Tabla de contenido
