Publicidad
Idiomas disponibles
Idiomas disponibles
40"
Split Jambs
Temporary
Brace
Hanger
Post
Door
Door Plate
8. Installing Bumper
Bumper
9. Installing Temporary Brace (Optional Step)
Support
Leg
10. Installing Door Plates on Door Panel
Position both Door Plates on top side of door panel at least 1 3/4"
in from left and right edges of door panel as shown. Secure Door
Plates to top of door panel using eight (8) #10 x 1 1/2" screws, 4
for each door plate.
Hanger
Door
Using one (1) #8 x 5/8" screw, secure Bumper to rough jamb
at the back of pocket approximately 40" from floor.
Insert 1" x 2 1/8" board through Split Jambs, with the board
resting on Bumper; nail a support leg to board as shown.
This brace is for added support while installing drywall,
paneling, or other wall covering material. Remove brace
prior to installing door.
Door Plate
11. Installing Door
a) Insert door onto Hanger by
lifting the door and sliding Door
Plate onto post as shown.
b) Using the wrench provided
turn the post to adjust the door
vertically so it has sufficient floor
clearance and is plumb. Do not
unscrew post from Hanger.
c) When door is in position you
need to lock the door plate.
Publicidad
