Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
HOW TO USE
CAUTION:
Do not attempt to cut panels of thicknesses
that are beyond the capability of the hand
shear. Doing so will result in premature
breakage of the hand shear.
Perform the cutting operation only after the
panel is fixed securely.
When cutting thin panels, level the unit
horizontally, as shown in Fig. 4.
To facilitate smooth cutting of thick panels, if
the cut-off side goes toward the left, (Fig. 4)
raise the rear of the unit slightly. And if the
cut-off side goes toward the right, lower the
rear of the unit slightly.
HOW TO REPLACE THE BLADE
The hand shear uses disposable blades. Each
blade has 8 cutting edges, as shown in Fig. 5.
After a cutting edge cuts 1300 ft.(400m) of
panel, cutting performance will fall. Then use
another cutting edge. After all 8 cutting edges
are used and worn, replace the blade.
12
All manuals and user guides at all-guides.com
Fig. 4
Stationary Blade
Moving Blade
Cutting Edge
Fig. 5
Publicidad
Tabla de contenido
