Assembly - Home Decorators Collection BRUNFIELD BUGVT6122 Guía De Uso Y Mantenimiento

Assembly

1
Preparing the wall
□
Measure a vertical distance of 30-3/4" from the oor using
a tape measure, and mark on the wall with a pencil. This
will be the height of the wall brackets (AA).
□
Place a long plywood support board along the wall where
the vanity (A) will be installed.
plywood board and cut out the drywall with the drywall
saw, exposing the wall studs.
□
Attach the plywood support board to the wall studs using
long wood screws and a drill.
35"
3
Hanging the vanity
□
Lift the vanity (A) above the brackets (AA) and place it
against the wall.
□
Slide the vanity (A) to the left or right to the desired location.
□
Slide the vanity (A) down the wall, hooking it onto the
brackets (AA).
Trace out the position of the
30-3/4"
A
AA
2
Installing the mounting brackets
□ Place the mounting brackets (AA) against the support board and
determine the desired hanging location. Using a pencil, mark
7 locations on the wall that match up with each brackets (A) holes.
□
Ensure the marks are horizontally straight by using a level.
□
Insert the short screws (BB) through the bracket (AA) holes
and screw them into the support board.
4
Adjusting the levels
□
Adjust the top bolt (1) to tilt the vanity (A) from front to back.
□
Adjust the bottom bolt (2) for leveling the vanity (A) left or right.
□
After all adjustments are completed, replace the plastic cap.
4
AA
MAX. 59"W
1
2
A
BB