Changing Attachments (See Fig. G, H, I); Removing Nose And Ear Hair - Silvercrest SMT 3 A1 Manual De Instrucciones E Indicaciones De Seguridad

SilverCrest SMT 3 A1

8.3 Changing attachments (see Fig. G, H, I)

Always turn the multi-trimmer off to change an attachment (2,
5, 9). Remove the protective cover if applicable (10). It just
slides on and can be pulled off/put on without a lot of force.
Remove an installed attachment (2, 5, 9) by holding the
•
multi-trimmer with one hand, grasping the attachment (2,
5, 9) with the free hand and turning anticlockwise to the
stop. Now take the attachment (2, 5, 9) upwards off the
trimmer housing (3).
To install an attachment (2, 5, 9), put it onto the trimmer
•
housing from above (3). Note the markings on the
attachment (2, 5, 9) and on the trimmer housing (3). Lock
the attachment (2, 5, 9) by turning it clockwise to the stop.

8.4. Removing nose and ear hair

Use the nose and ear hair trimmer attachment (2).
•
Remove the protective cover (10).
Turn the multi-trimmer on.
•
CAUTION! Risk of injury!
To avoid injury, do not insert the blade protector (1)
too far into the nose or ear! Only insert the tip of the
blade protector (1) into the outer area of the nose
or ear.
Remove nose or ear hair with small, circular movements.
•
Turn the multi-trimmer off after use.
•
Replace the protective cover (10).
•
48 - English