Troubleshooting Guide - Duronic CG250 Manual De Instrucciones

Problem
The grinder does
not work after
being switched
on
The grinder stops
working during
operation
The machine
starts to make a
bad smell
Abnormal
vibration or noise

Troubleshooting Guide

Possible
Cause
The grinder lid was not
properly in place so it did
not connect with the power
activating buttons on the
motor unit.
The 3 touch sensors on the
top of the motor unit may be
obstructed by something.
Check if the power cable/
plug is loose.
Check if the motor unit is
too hot.
With new products that
contain a motor it is normal
for it to emit a smell upon
first use.
Unstable positioning of the
grinder unit.
The lid, grinding pot,
blade or base is loose or
damaged.
Check the grinder lid and ensure it is
properly in place.
Check and clean/clear the 3 sensors
if they are dirty or have anything
obstructing them.
If the power cable is loose, push it
back into the socket and switch it on.
If the motor unit has overheated the
grinder will need to rest and cool down
before you can continue using it.
If it does not work after cooling down,
please contact Duronic for further
The smell should fade upon use of the
grinder. If the smell persists after a few
uses, contact Duronic for advice.
Reposition the grinder on a smooth
If any parts are damaged, do not use
the grinder. Contact Duronic directly
where you should be able purchase
the replacement part you need.
12
Suggested
Solutions
advice.
even surface.