Publicidad
Idiomas disponibles
Idiomas disponibles
1f. Using a 10mm socket remove (3) bolts that attach the fascia to the underbody near
the center of the vehicle.
1h. Using a T15 torx loosen the top (2) screws from the wheel well trim, using a phillips
screwdriver remove (2) screws inside the wheel well to remove the wheel well trim. Pull
back the wheel well liner to expose (2) phillips head screws. Remove the (2) screws. See
Fig. 3.
©2018 Horizon Global Americas Inc. - Printed in Mexico
1g. Remove the hitch access panel in the middle of the fascia, remove (2) phillips head
screws that hold the fascia to the vehicle.
1 i. Starting from the wheel well area, gently pull the fascia away from the vehicle (be
careful not to pull it too far away from the vehicle to avoid damage) work your way
toward the middle from each wheel well. Unplug (2) electrical connectors from behind
the fascia near the driverside wheel well.
Sheet 5 of 21
76260NP
10-17-18
Rev. B
Publicidad
