Remote Control; Power Supply; Clock Setting - Roadstar HRA-250IP/WH Manual De Instrucciones

No user serviceable parts inside. Refer servicing to qualified service personnel.
Safety Precaution
Do not allow this unit to be exposed to rain or moisture.
Mains Supply (AC ADAPTER): AC230Volts / 50Hz - AC only
This symbol means that this unit is double insulated. An earth connection is not
required.

POWER SUPPLY

Remove the stereo carefully from the box, retaining the packaging for future use.
Read these instructions carefully before use.
Connections
AC ADAPTER
Connect the (8) to an AC outlet. Check that your mains supply is 230V, 50Hz.
Extend the FM antena on the rear of the unit (17).
Disconnect the AC power Adapter from the mains if the unit is not going to be used for some
time.
BATTERY INSTALLATION (REMOTE CONTROL)
Insert one CR-2025 battery into the battery compartment of the remote controller and replace
the cover.
BATTERY REPLACEMENT
When the batteries become too weak, the
operating distance of the remote controller
is greatly reduced and you will need to replace
the batteries.
Notes: To maintain the accuracy and long life
of the transmitter, do not press two or more
Buttons simultaneously.
If the remote control is not to be used for a long time, remove the batteries to prevent possible
damage through leaking batteries.
USING THE REMOTE CONTROLLER CORRECTLY
Point the remote controller at the Remote Sensor in front of the unit.
The functions of the buttons on the remote control are the same as the corresponding controls
on the main unit.
English 3 4 English
When there is a strong ambient light source, the performance of the infrared Remote Sensor
may be degraded, causing unreliable operation.
The maximum effective distance for remote control operation is about 5 metres (16.5 feet).

REMOTE CONTROL

1. STANDBY BUTTON
2. MUTE BUTTON
3. PRESET (Radio) UP / DOWN BUTTON
4. SLEEP BUTTON
5. BASS AUDIO CONTROL
6. SKIP/TUNING/SEARCH DOWN BUTTON
7. TREBLE AUDIO CONTROL
8. VOLUME DOWN BUTTON
9. SOURCE BUTTON
10. SNOOZE / DIMMER BUTTON
11. PRESET(Radio) BUTTON
12. ALARM 1 / 2 BUTTON
13. PLAY/PAUSE (only iPod) BUTTON
14. SKIP/TUNING/SEARCH UP BUTTON
BATTERY INSTALLATION (MEMORY BACK-UP)
Insert TWO UM-3 battery into the battery compartment on bottom side and replace the cover.

CLOCK SETTING

In the STANDBY mode:
1. Press the TIME SET (5) button.
13
17
1
2
4
9
6
14
12
11
8
5
3
7
10