Important Notice - Labelmate MC-10 Manual Del Usuario

About your rewinder
LABELMATE MINI-CAT REWINDERS MC-10 and MC-10 +
winders to be used in combination with small desktop or mid-range barcode printers. With a specially designed bi-direc-
tional motor, they offer trouble-free performance for many years at an incredible low cost.
FEATURES
• Maximum Label Roll Weight: 3 KG
• Maximum Label Width: 125 mm
• Maximum Roll Diameter: 220 mm
• Maximum Speed: 50 CM/SEC at the beginning of a 76 mm core roll
• An external command interface on the '+' models to support direct control start/stop by the barcode printer (check
compatibility with your printer vendor). The MC+ can react to different types of signals provided by the printer. Please
note that Labelmate does not provide custom build cables to specific printer models/interfaces.
DIMENSIONS
• W x D x H: 220 x 305 x 195 mm
• Weight: 5.6 KG

IMPORTANT NOTICE

• Remove all parts from the shipping container and verify contents.
• User Manual (this document)
• Label Rewinder Unit
• Power Supply Module
• Retain the Shipping Container and Packaging for Storage and Transport
SET-UP
• Place the MC-10 with the Rewind Shaft perpendicular to the web of the labels to be rewound, and near where the labels
come out of the printer. The MC-10 is bi-directional, so can be operated in either direction.
• Verify that the (ON/OFF/ON) Switch on the rear of the Unit is in the OFF (0) position.
• Insert the Power Cord into the Power Socket on the rear of the MC-10.
• Plug the AC/DC Adapter into a suitable electrical outlet. It can be left plugged in at all times.
• The MC-10 has a combination Power and Direction (ON/OFF/ON Direction) Switch on the Rear Panel. The Centre Po-
sition of the Switch is "OFF" (0). To make the Rewinder run to the right (looking from the rear of the Rewinder), press
the Power / Direction Switch in the direction of the right arrow. To make the Rewinder run to the left, press the Power /
Direction Switch in the direction of the left arrow.
REWINDING LABELS DIRECTLY ON SHAFT (CORELESS)
• Slide the hook-shaped metal Bail onto the MC-10 Shaft. The straight end goes into the hole in the plastic Flange Plate.
The curved end fits into the small hole in the outer end of the Shaft.
• Insert the label web under the Bail and turn the Rewind Shaft by hand to secure the labels.
• Place the MC-10 (ON/OFF/ON Direction) Switch to the ON position in the desired direction of operation, left or right.
• Start the printer and observe that the labels are being rewound correctly. You can adjust the speed/torque by turning the
potentiometer on the upper part of the machine to provide more, or less, rewind force as desired.
• 5. When rewinding is finished, place the MC-10 (ON/OFF/ON) Switch in the OFF (0) position.
• To remove the labels, first pull out the hook-shaped Bail from the centre of the label roll. Then remove the labels.
are the world´s most popular entry-level label re-
GENERAL
• Power Supply: 15VDC 1600mA
• Limited Warranty of 5 Years, 1 Year on the Power Supply
Labelmate.com