Getting Started - Labelmate MC-10 Manual Del Usuario

Getting started

3
4
REWIND ON A CARDBOARD CORE
• To use a cardboard core, install the 3-stainless steel Fins (Vanes) onto the Rewind Shaft of the MC-10 using the 6-screws
provided. For narrow cores, orient the Fins next to the plastic Flange. Slide an empty cardboard core over the Fins and
up against the plastic Flange Plate.
• Use a piece of masking tape to secure the label web to the cardboard.
• Place the MC-10 (ON/OFF/ON Direction) Switch to the ON position in the desired direction of operation, left or right.
• Start the printer and observe that the labels are being rewound correctly. You can adjust the speed/torque by turning
the potentiometer on the upper part of the machine to provide more, or less, rewind force as desired. When rewinding
is finished, place the MC-10 (ON/OFF/ON Direction) Switch in the OFF (0) position.
• Slide the cardboard core and the labels off the MC-10.
EXTERNAL CONTROL, ONLY FOR + MODEL
The MC+ can be controlled by the printer. A 3.5mm (mono) con-
nector for an External Control Input (start/stop) is provided and a
matching jack is enclosed. The MC+ can react to different types
of signals provided by the printer. The selection of the signal na-
ture is done via 2 jumpers on the MC+ internal PCB. Four modes
are selectable: Open Collector High Active, Open Collector Low
Active, Logic Level High Active (Max 10VDC) & Logic Level Low
Active (Max 10VDC).
The factory setting is "Open Collector high". Other default setting
on request.
Labelmate - The World's Leading Manufacturer of Label Dispensers, Rewinders, Unwinders, Slitters & Counting Solutions
• 1- BAIL
• 2- FINS (3P)
• 3- SPEED SELECTOR
• 4- INNER-FLANGE
2
• 5- ON/OFF/DIRECTION
SWITCH
1 • 6- EXTERNAL HALT on MC-+
model only
6
SIG ACT LOW
SIG ACT HIGH
OPEN COL LOW
OPEN COL HIGH
5
JP2 JP3
1
2
x 1
x 2