Getting Started - Levenhuk Wezzer PLUS LP20 Guia Del Usuario

L
evenhuk Wezzer PLUS LP20 Thermohygrometer
EN
The kit includes: base station, 3 sensors, user manual, and warranty.
Also required (not included):
2 AAA batteries for each sensor
2 AA batteries for the base station

Getting started

Base station
• Open the battery compartment cover (13) and insert 2 batteries according to the correct
polarity. Close the cover.
• Wait until the indoor temperature is displayed on the base station.
Sensor
• Open the battery compartment cover (8). Set the desired channel with the switch.
NOTE! This weather station can be operated with up to 3 remote sensors. Each remote
sensor that is to be connected must be operated on a different channel. If only one
remote sensor is connected, it should be operated on channel 1.
• Insert 2 batteries according to the correct polarity. Close the cover.
• To re-establish the sensor connection manually, press RESET using a pin.
Sensor connection
• Place the base station and the remote sensor within the effective transmission range. Ensure
that the channels are assigned after you set up the power supply for the base station and all the
sensors.
• If the reception is successful, the display will show the temperature and humidity of the
respective outdoor sensor. If the values are not received from a channel, "—" appears on the
display. Check the batteries and try it again. Check if there is any source of interference.
• When changing batteries, replace the batteries first in the base unit, and then in all the sensors,
to re-establish the connection. If an adapter supplies power to any of the devices, briefly
disconnect the power to that device when replacing the batteries. If you change the batteries
only in one of the devices (for example, in the sensor), the signal may not be received correctly.
• The effective range may differ depending on the unit's position. Due to interference (various
remote control devices, etc.), the maximum distance between the base unit and the sensor
may be significantly reduced. In such cases, we suggest moving the base unit and sensor a little.
Sometimes it is enough to move one of these units a few inches!
NOTE! Although the sensor is weather resistant, never place it in direct sunlight or in the
rain or snow.
6