Midea MAW12HV1CWT Manual Del Usuario página 9

Before installing unit, the top rail must be assembled on the unit.
A: Remove the air conditioner from the carton and place on a flat surface.
B: Remove top rail from the rear of the packaging material as shown in Fig. A.
C: Align the hole in the top rail with those in the top of the unit as shown in Fig. B.
D: Secure the top rail to the unit with the 3/8" Screws as shown in Fig. C.
Packaging
Installation
LEFT + RIGHT FILLER PANEL ASSEMBLY
NOTICE
Top Rail and Side Panels at each side are offset to provide the proper pitch to
the rear of (5/16"). This is necessary for proper condensed water utilization and
drainage. If you are not using the Side Panels for any reason, this pitch to the rear
must be maintained!
1. Install Side Filler Panels
Place unit on floor, a bench or a table. There is a left and right side filler panels - be sure
to use the proper panel for each side. When installed, the flange for securing the panel
in place to the window sill will be facing into the room.
A. Hold the side panel in one hand
and gently pull back the center
to free the open end. See Fig. 1.
B. Slide the free and "T" section
of the panel directly into the
cabinet as shown in Fig. 2.
Slide the panel down. Be sure to
leave enough space to slip the
top and bottom of the frame
into the rails on the cabinet.
Fig. A
Fig. B
Top Rail
Fig. C
Fig. 2
Fig. 1
 Page 9 
" " section
T
Fig. 2