Power Supply; How To Scan - Datalogic Magellan 1000i Guía De Referencia Rápida

Optional Stand
An optional stand is available for the scanner which can be
permanently attached to a wall or countertop. After locating the
stand in an optimal position, the scanner (along with the stand)
can be detached for portable use by lifting the entire unit as
shown below.

Power Supply

1
Models require either a Listed class II or class III with a Limited
Power Source (LPS). For the safety certification to be valid, class
III input power sources must be IEC/EN60950-1 (EN 60335-
series, EN 60065 or relevant) approved.
Input: 100 - 240 VAC
Max. Current: 1 A

How to Scan

Bar codes can be presented to the scanner while it is resting on
the counter or in the optional stand, or the scanner/mount can be
lifted and held as shown.
*Optional Stand
1. Power Off the Terminal (POT) units do not require a power supply.
2
All manuals and user guides at all-guides.com
Output: 5 - 14 VDC (check scanner voltage option)
Max. Power: 14 W
Switch Option Shown
®
Magellan 1000i