General Orientation - Schulz Air Plus 12V Manual De Instrucciones

• Flashlight (Air Plus 12V Digital Schulz)
You just have to fl ip the switch to the "LIGHT" position for continuous use of the fl ashlight or "FLASH" for intermittent warning
light. You can use the fl ashlight simultaneously with the compressor on (Figure 7.5).
Compressor Air Plus 12V Duo Schulz - To infl ate tires:
1.
Check if the tire valve is in position you can reach. It should be placed preferably close to the ground. That will make the
connection easy and prevent the valve from moving to the inside of the wheel;
2.
Connect the plug to the cigarette lighter or power outlet, if available (Figure 7.1), or to the main (127 or 220 volts);
3.
Connect the hose tip to the tire valve and lock it (Figures 7.2 and 7.3);
4.
Flip the switch of the compressor to the "DC" 12 Volts position when using the cigarette lighter of the car or to the "AC"
position when using the power outlet of the mains (Figure 6);
5.
When the desired pressure of the tire is reached, turn off the switch (Figure 7.6) and disconnect the plug from the power
outlet.
Important: When connecting the Compressor Air Plus 12V to the cigarette lighter of the car, use the "DC" position, and when
connecting it to the mains outlet, the "AC" position.
ATTENTION
Provide for battery recharge after 30 minutes of product use.
FIGURE 7.1
FIGURE 7.5
For other infl atables. Follow the previous procedures, selecting the appropriate nozzle, connecting it to the tire infl ating hose
nozzle (Figure 7.8).

8. GENERAL ORIENTATION

1.
This product is not intended for any use other than the indicated in this manual.
2.
Compressor not suited for activation of painting pistols, spraying, airbrush, and cleaning nozzles.
3.
Only connect it to 12 Volts direct current power sockets or cigarette lighters.
4.
Check the maximum pressure limits of tires and other infl atables, according to their manufacturer specifi cation,and do not
exceed these limits. Above the required pressure, some objects may cause the infl atable to blow up, possibly resulting
in severe accidents.
5.
Do not connect the compressor to other sites of the vehicle, such as lighting cables, signaling, panel commands and fuse
box.
6.
The maximum suggested continuous functioning of this product is 10 minutes. A longer period may cause overheating
and damage to the product.
7.
7. Do not allow the compressor to work without supervision by a responsible person.
The use of this product may drain the vehicle battery. Before use, be sure that the battery is fully
charged and in good use conditions.
FIGURE 7.2
FIGURE 7.6
FIGURE 7.3
FIGURE 7.7
14
FIGURE 7.4
Open
Closed
FIGURE 7.8