Note: To start immediately using this flash please refer to the Quick-Start guide.
For advanced features please read this manual and be familiar with your camera
manual and operations.
The Phottix Mitros+ TTL Transceiver Flash for Nikon is designed to work with
Nikon DSLR cameras and features TTL, Manual, Multi modes as well as Wireless
Master/Slave triggering.
Warnings
1. Use your flash safely. Do not fire the flash into the eyes of people or animals at
short distances - damage and/or blindness can occur.
2. Be careful using the flash in or around cars, buses, motorcycles or other mov-
ing vehicles as accidents can result.
3. Never use the flash near combustible gases (gasoline, solvents, etc.).
4. Do not expose the flash or batteries to dripping/splashing water, or high hu-
midity.
5. Do not leave the flash or batteries in a hot location (direct sunlight, in a closed
car, etc.).
6. Remove batteries from the flash when not being used for an extended period
of time.
7. Change the batteries when required. Use undamaged batteries in good con-
dition. Do not mix battery types or new and used batteries.
8. Do not put opaque objects in front of the flash lens when firing the flash. The
energy emitted by the flash may cause objects to burn, or cause damage to the
flash tube or fresnel lens.
9. Use caution in touching the flash head after use. It may be hot and can cause
burns.
10. The flash contains high voltage electronic parts. Do not disassemble or at-
tempt to repair the flash. Never touch the flash's internal components.
11. Do not touch the External Power Port contacts with any metal objects - this
can cause electric shock and serious injury.
Table of Contents
Modes .........................................................................................7
Custom Functions.....................................................................13
Technical Specs.........................................................................15
2
Phottix Mitros+ TTL
Transceiver Flash
for Nikon
INSTRUCTION MANUAL
En
Parts
Back / Left Side
1. LCD Display
2. Mode Button
3. Test Button
4. Power Switch
5. Ready Light
6. Arrow Adjustment
Buttons (see below)
7. Set Button
8. Locking Lever
9. 3.5mm Sync Port
10. USB Port
11. External Power Port
Arrow Adjustment Buttons
1. Up Arrow / Zoom Adjustment Mode Button
2. Right Arrow / Wireless Flash Mode Button
3. Down Arrow Button
4. Left Button / Custom Functions Button
Front / Right Side
1. Bounce Card
2. Wide Angle Diffuser
3. Flash Head
4. Wireless Signal Receiver Area
5. AF Assist Light
7. Battery Compartment