Description; Purpose; Overview; Safety - Cramer A48T10E-CR Manual Del Usuario

EN
1

DESCRIPTION

1.1

PURPOSE

This edger is used to trim and cut around the edge of
driveways, side walks and more. The edger is not meant to be
used to cut hedges, shrubs, bushes, or flowers.
1.2

OVERVIEW

Figure 1 - 9.
Edger attachment
1
Guard
2
Blade
3
Wheel
4
Depth adjustment knob
5
Release button
6
Position hole
7
Coupler
8
Knob
9
Nut
10
Outer cup
11
Plate
12
Metal rod
13
Skid plate
14
Washer
15
Axle sleeve
16
Wheel axle
17
2

SAFETY

Make sure that you follow all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
WARNING
WARNING
WARNING
English
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
3.2

ASSEMBLE THE SHAFT

Figure 2.
1. Loosen the knob on the coupler.
2. Push in the release button on the lower shaft.
3. Align the release button with the positioning hole and
move the two shafts towards each other.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the knob.
4

OPERATION

Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
4.1

ADJUST THE DEPTH OF CUT

Figure 3 - 4.
1. Remove the battery pack.
2. Loosen the depth adjustment knob to increase or decrease
the depth.
3. Adjust the depth so that the blade barely touches the
ground when the machine is held in a normal operating
posture.
4. Tighten the depth adjustment knob.
5. Standing in a normal working position, check the depth of
cut again and correct if necessary.
6. Replace the battery pack once all adjustments are
complete.
4.2

OPERATION TIPS

Figure 9.
Always hold the edger away from the body keeping
clearance between your body and the edger. Any contact
with the edger cutting head while operating can result in
serious personal injury.
• Hold the edger with your right hand on the rear handle
and your left hand on the front handle.
4
IMPORTANT
WARNING
WARNING