Sanus BMT1 Manual De Instrucciones página 24

4. Place wall plate template
CAUTION:
Avoid potential personal injury or property damage! SINGLE STUD installs MUST use the center holes in the stud as shown.
NOTE: For assistance in determining wall plate location, see HeightFinder at sanus.com.
IMPORTANT
: Be sure you mark and drill into the center of the stud.
5. Drill the four pilot holes using a 1/2 in. (13 mm) diameter drill bit in the locations illustrated for double stud or single stud installs.
IMPORTANT
: Pilot holes must be drilled to a depth of 1 in. (25 mm).
4
24
at your desired height and position over your stud center line(s). Level wall plate template
06
DOUBLE STUD
06
SINGLE STUD
06
5
1 in. (25 mm)
1/2 in.
(13 mm)
and tape in place.
06
DOUBLE STUD
06
SINGLE STUD
06