Lumatek Controller Troubleshooting - Lumatek CONTROL PANEL PLUS 2.0 Manual Del Usuario

CONDITION
Ballast Locked
Cycle Error
Low Mains
Over Temperature
High Mains
Note! To reset ballast; disconnect from mains and reconnect after 30 seconds
Warning! When replacing a lamp, always switch Off ballast first by removing
plug from power supply. Never switch off lamp by removing lamp cable from
a live ballast.

8. LUMATEK CONTROLLER TROUBLESHOOTING

FAULT
Controller doesn't have
any display after
connecting to power
Fail to control ballasts
Controller doesn't have
any temperature display
after the temperature
probe is connected
Fail to turn on lamp
Ballast output power is
not same as command
signal sent from controller
When several ballasts
are working together,
some units are working
well but some fail to work
LED STATUS
Flash*1
Flash*2
Flash*3
Flash*4
Flash*5
INSPECTION METHOD
Check the Power Supply
Check the Adaptor
Check the Controller
Check the connection between
controller and ballasts;
make sure each connection
is well-plugged.
Check if the temperature
probe is damaged.
Check 'controller' LED
on ballast is flashing normally
Check the Sun rise and
set time periods
Check the temperature
probe & temperature
control values set.
Check control cable
connections
Check if the ballast
is faulty
DESCRIPTION
Maximum amount of ignition
attempts without success
Lamp stopped for unknown reason
or output signal interrupted.
Mains Voltage too Low
Maximum driver temperature exceeded
Mains Voltage too High
TROUBLESHOOTING
Waiting for power supply to return
Change the Adaptor
Change the Controller
Reconnect the control cables
Change to another
temperature probe
Reconnect Cables
Reset or switch off sun rise
/set time period.
Reset temperature
control values.
Disconnect and reconnect
control cable or replace cable.
Check LED failure
indicator on ballast.