Assembly And Adjustment - DeWalt DW341M Manual De Instrucciones

Assembly and Adjustment

WARNING: Prior to assembly and adjustment always unplug the
tool.
FITTING AND REMOVING A
SAW BLADE (FIG. B)
WARNING:The saw blade could
be hot due to the work process. So
when changing the saw blade
make sure that it is chilled cooled
off or wear protetive gloves when
touching the blade.
• The tool-free blade exchange
system ensures quick and
easy changing of saw blades.
• Open the blade holder (7) by
fully retracting the blade latch
(5).
• Insert the saw blade into the
blade holder (7) guiding the
back of the blade into the
groove of the guide roller (8).
• Release the blade latch (5).
• To remove the saw blade, fully
retract the blade latch and pull
the blade out of the holder.
SETTING THE BEVEL ANGLE
(FIG. C)
The adjustable shoe (9) allows
cutting of LH and RH bevel
angles up to 45°. The bevel scale
has preset positions at 0° and
45°.
FIG. B
FIG. C
5 5
• Slacken the screws using the supplied wrench.
• Slide the shoe (9) toward the saw blade.
• Tilt the shoe and set the desired bevel angle using the scale.
• Tighten the screws.
Instructions for use
WARNING:
• Always observe the safety instructions and applicable
regulations.
• Make sure your workpiece is well secured. Remove nails,
screws and other fasteners that may damage the blade.
• Check that there is sufficient space for the blade underneath
the workpiece. Do not cut materials that exceed the maximum
cutting depth of the blade.
• Use sharp saw blades only. Damaged or bent saw blades
must be removed immediately.
• Do not use the tool for sawing pipes or tubes.
• Never run your tool without a saw blade.
• For optimal results, move the tool smoothly and constantly over
the workpiece. Do not exert lateral pressure on the saw blade.
Keep the shoe flat on the workpiece and lead the cord away
in line with the tool. When sawing curves, circles or other
round shapes, push the tool gently forward.
• Wait until the tool has come to a standstill before removing the
saw blade from the workpiece. After sawing the blade may be
very hot. Do not touch.
SWITCHING ON AND OFF (FIG. A)
• To run the tool, press the on/off switch (1).
• For continuous operation, press and hold down the switch (1),
press the lock-on button (2) and release the switch.
• To stop the tool, release the switch.