DeWalt DW341M Manual De Instrucciones página 7

• To stop the tool in continuous operation, press the switch briefly
and release it. Always switch off the tool when work is finished
and before unplugging.
SETTING THE ELECTRONIC
SAWING SPEED (FIG. E)
The sawing speed varies with the
pressure exerted on the on/off switch
(1).
• To preset the sawing speed, turn the
control dial (3) to the desired level.
The higher the rate, the higher the
sawing speed. The required setting
depends on the thickness and kind
of material.
• Use high speeds for sawing soft
materials such as wood. Use low
speeds for sawing metal.
WARNING: After using the tool for an extended period on low
speed settings, run it for approx. 3 minutes on maximum no-load
speed.
HOLDING THE TOOL (FIG. F)
• Hold the tool as shown.
SAWING IN WOOD
• If necessary, draw a cutting line.
• Switch the tool on.
• Hold the tool against
workpiece and follow the line.
• For sawing parallel to the edge
of your workpiece, install the
parallel fence and guide your
jigsaw along the workpiece a
shown in figure G.
FIG. E
FIG. F
the
SAWING IN WOOD USING A PILOT HOLE
• If necessary, draw a cutting line.
• Drill a hole (ø min. 12 mm) and introduce the saw blade.
• Switch the tool on.
• Follow the line.
• For cutting perfectly round shapes, install the trammel bar and
set it to the required radius (fig. H).
FIG. G
MAINTENANCE
Your D WALT power tool has been designed to operate over a
E
long period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and regular
cleaning.
Cleaning
CAUTION: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap.
Do not use gasoline, turpentine, lacquer or paint thinner, dry
cleaning fluids or similar products. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
6 6
FIG. H