Tripp-Lite B127A-4X2-BH2PH Manual Del Propietário página 11

RS-232 Serial Control
3 Next, you will need to configure your software to allow input control. Go
to the Setup drop-down menu and select the Terminal option.
4 Update the following settings: Receive (LF), Local Echo (enable). The
other settings can remain unchanged.
5 Once these settings are updated, the Terminal Emulation Software will
recognize the switch, allowing you to enter commands to control the
unit. The following table lists the available commands:
Command Action
sw[x] [n] Switches the source being displayed on the selected output. [x]
is the output (1, 2, 3, or 4) and [n] is the desired source (A,
B, C, or D). For example, a command of sw1 A would display
source A on output 1.
PWD Turns power to the switch on/off.
STE Displays the current output state, showing which source is being
displayed on each output.
11