Labelmate TWIN-MATRIX Serie Manual Del Usuario página 7

USING THE TWIN-MATRIX OFF-LINE WITH UNWINDER
• The Bracket Guide(BG) is mounted on the Right side for labels with a path going from Right to Left (FIG.4)
• Loosen (but leaving in the chassis to avoid loss) the 3 screws on the chassis and slide the BG in between the screws
and chassis as shown in FIG.1 (screw 1/2/3)
• DO NOT install the TENISON ARM (FIG.7) but cover the sensor with the small shield, included in your packaging and
shown in FIG.8.
• The shield will activate both motors permanently, speed and torque is set on the control panel
• Ensure to put the potentiometers both on ZERO at the start and at the end of a job and gradually increase the speed with
the potentiometer to launch your rewinding job.
Labelmate.com