Control And Operation - Maxon CIC Europe CM10 Manual Del Usuario

All manuals and user guides at all-guides.com
User Manual CM10
Control & Operation
Front Panel
1. AM/FM Selector
This key allows the user to select the AM or FM operating mode in both RX and TX. The AM/FM
operating mode selection is possible only if it is enabled on the programmed frequency band.
2. CH9/CH19 Selector
This key allows quick access to one of the two pre-programmed emergency channels (CH9 and
CH19). Each time this key is pressed, the radio will select CH9, then CH19, then again the normal
operating channel. When one of the emergency channels is selected, EMG will appear on the LED
display. The operating mode (AM or FM) for the emergency channels is factory pre-programmed.
3. TX Indicator
This red LED indicator lights up when the radio is in transmit mode.
4. FM Indicator
This green LED indicator lights up when the radio is in FM mode.
5. LED Display
The large two-digit LED display indicates the operating channel and the programmed frequency
band code.
6. DN (Down) Key
This key allows selection of the operating channel in decrements. By keeping this key pressed,
the quick channel selection mode will be enabled.
7. UP (Up) Key
This key allows the selection of the operating channel in increments. By keeping this key pressed,
the quick channel selection mode will be enabled.
Page 4 of 55