Operational Test; Frequency Bands Table; Frequency Band Selection - Maxon CIC Europe CM10 Manual Del Usuario

All manuals and user guides at all-guides.com
User Manual

Operational Test

Once radio has been connected to the vehicles electricity supply and to the antenna, the correct
operation of the system may be checked. Please proceed as follows:
1) Check that the power cable is correctly connected.
2) Check that the RF antenna coaxial cable is correctly connected.
3) Connect the microphone to the connector (located on the front side of the radio).
4) Rotate the SQUELCH knob counter clockwise.
5) Turn radio on using the OFF/VOLUME knob and adjust volume to the desired level.
6) Select the desired channel, using the channel selector keys.
7) Rotate the SQUELCH knob clockwise, to cut the background noise.
8) Press the PTT key to transmit and release it to receive.
If this check is successful the transceiver will work correctly.

Frequency Bands Table

The CM10 transceiver includes an advanced multi-standard programmable circuit, which allows
programming on different frequency bands, specifications and operating modes, in conformity
with the regulations in the country where the product is used. 8 programmable frequency bands
are available, as per the below table:
COUNTRY
COUNTRY
CODE
01 ITALY / SPAIN
02 ITALY
03 GERMANY
04 GERMANY
05 EUROPE / FRANCE
06 CEPT
07 UK
08 POLAND
Attention! This radio has been factory pre-programmed on the CE frequency band (CEPT 40CH FM 4W),
as this standard is currently accepted in all the European countries. Please refer to the information table at
page 1 (Restrictions on the use of CB transceivers).
Frequency Band Selection/Programming
This two-way CB radio must be programmed and exclusively used on a frequency band allowed in
the country where the product is used. When radio is switched ON, the current programmed
frequency band code will be displayed (blinking) for around 3 seconds. To program a different
frequency band, proceed as follows:
1) Turn the radio OFF.
2) Press and hold the UP key, then turn the radio ON using the OFF/VOLUME knob.
3) The current frequency band code will blink on the display.
4) Now select the new desired frequency band code by pressing the UP or DN key; during the
frequency band selection process, the frequency band display will blink at a faster rate.
5) Press and hold the DN key to confirm and store the new selected frequency band code.
Page 8 of 55
SPECIFICATIONS (CH, operating modes, TX power)
40CH AM / FM 4W
36CH AM / FM 4W
80CH FM 4W - 12CH AM 1W
40CH FM 4W - 12CH AM 1W
40CH FM 4W - 40CH AM 1W
40CH FM 4W
40CH FM 4W UK FREQUENCIES -40CH FM 4W CEPT FREQUENCIES
40CH AM / FM 4W POLISH FREQUENCIES
CM10