Bosch GLM Professional 100-25 C Manual Original página 31

Li-ion rechargeable battery
GLM 150-27 C
Charging the Li-ion Battery
For recharging, use a USB power supply unit whose technical data (voltage and char-
u
ging current) corresponds to that of the recommended power supply unit. Observe the
operating manual of the USB power supply unit.
Recommended power supply unit: See technical data.
Pay attention to the mains voltage. The voltage of the power source must match the
u
voltage specified on the rating plate of the power adaptor. Power adaptors marked
with 230 V can also be operated with 220 V.
Lithium-ion rechargeable batteries are supplied partially charged according to in-
ternational transport regulations. To ensure full rechargeable battery capacity, fully
charge the rechargeable battery before using your tool for the first time.
For more information, you can access the online operating instructions at
www.bosch-pt.com/manuals
Operation
Start-Up
Never leave the measuring tool unattended when switched on, and ensure the
u
measuring tool is switched off after use. Others may be dazzled by the laser beam.
Protect the measuring tool from moisture and direct sunlight.
u
Do not expose the measuring tool to any extreme temperatures or variations in
u
temperature. For example, do not leave it in a car for extended periods of time. In case
of large variations in temperature, allow the measuring tool to adjust to the ambient
temperature before putting it into operation. The precision of the measuring tool may
be compromised if exposed to extreme temperatures or variations in temperature.
Avoid substantial knocks to the measuring tool and avoid dropping it. After strong
u
external influences on the measuring tool, you should always carry out an accuracy
check (see "Accuracy Check", page 37) before further work.
Switching On and Off
Press the button to switch the measuring tool and the laser on.
Bosch Power Tools
English | 31
1 609 92A 6UN | (21.09.2021)