Roadstar CDR-265U Manual De Instrucciones página 5

• Discs should be returned to their cases after use. This avoids serious scratches that
could cause the Laser pickup to skip.
• Do not expose discs to direct sunlight, high humidity, or high temperatures for extended
periods. Long exposure to high temperatures can warp the disc.
• Do not stick paper or write anything with a ballpoint pen on the label side of the disc.
CD/MP3/USB PLAYBACK
Loading and Unloading Compact Discs
1. Press the Function Selector (9) to select CD function.
2. Open the disc compartment by pushing the CD OPEN corner (6).
3. When the door has opened, remove a disc from its case and place it carefully in the
compartment with the label side facing up. Locate 3" discs, on the central spindle in the
compartment.
4. Close the door by pressing on the corner of the CD door.
The total number of tracks appears on the display:Press PLAY/PAUSE Button ( II ) (17)
During playback, the actual track appears.
5. Adjust the VOLUME control to your desired listening level.
6. To stop playback temporarily, press the PLAY/PAUSE ( II ) button (17) once. The Play
indicator will flash on the display. Press the PLAY/PAUSE ( II ) button again to resume
playback.
7. To stop playback, press the STOP ( ) (19) button once.
8. To switch OFF the unit press the Stand-By button (2).
Notes:
• When the CD door is accidentally opened during playback, "OPEN" will appear on
the display.
• Wait until the disc is fully stopped before opening the CD (21)
compartment. • This unit can play 3" (8cm) single CDs without an adaptor.
Loading MP3 files from a USB memory Stick
1. Press the Function Selector (9) to select USB.
2. Press the PLAY/PAUSE/USB button (17) few seconds until 'USB' is shown on the display.
3. Connect the MP3 player to the USB port to switch it on.
4. Once playing, the USB MP3 track can be selected in the same way as the CD
tracks.
5
English
6
English
LOCATING A PARTICULAR TRACK OR POINT OF THE TRACK
1. Press the SKIP Back ( )(14) button once to go back to the beginning of the current
track.
2. Press the SKIP Back button repeatedly to go back to previous tracks.
3. Press the SKIP Forward ( )(13) button repeatedly to go to next tracks.
4. Press and hold either SKIP Forward or SKIP Back button to search backwards or
forwards, at high speed, a particular point of track.
Note: Low level audio will be heard during the search process to assist in locating the
correct point in the track.
Playability of self-made CDs on Roadstar CD drive mechanisms.
CD-R/CD-RW in CD-DA and in MP3 format can be played back. However it can occur,
due to differences in the quality of the media as well as the characteristics of the
recording, that individual self-made CDs cannot be read. This does not indicate an
incorrect function of the playback unit in these cases.
Concerning Compact Discs
Only compact discs identified with this mark can be used with
this player.
REPEAT PLAYBACK WITH CD / USB - MP3
1. Press the PLAY/PAUSE button (17)
2. To repeat the same track, press the P-MODE button (11) once. The indicator.
' compare on the display.
The CD will start single repeat playback until STOP button (19) is pressed. Press the
P-MODE button (11) button 4 times more to cancel single repeat. The indicator
disappears from the display.
3. To repeat the entire FOLDER, press the P-MODE button (11) twice.
appear FOLDER on the display (MP3 mode only).
Press the P-MODE button (11) button 3 times more to cancel all disc repeat. The
indicator FOLDER disappears from the display.
4. To repeat the the entere disc, press the P-MODE button (11) 3 times.
appear on the display.
Press the P-MODE button repeatedly until the indicator
display to cancel all repeat.
will
will
disappears from the