Brandson Equipment 305695 Manual De Instrucciones página 10

4. Programming codes
1. Briefly press the "P button (program button/code button)" on the door
drive. The LED on the drive starts flashing.
2. Briefly press the desired hand-held transmitter button on the Brandson
remote control. Please press the button again within the next 10 seconds.
Now the LED on the drive starts flashing quickly and soon goes off.
3. Then release the hand-held transmitter button. The LED on the drive glows
continuously and the hand-held transmitter is programmed.
5. Replacing the battery
Unscrew the back of the device using a suitable screwdriver. Remove the empty
battery and replace it with a 12V A27 battery. Always pay attention to the correct
polarity of the battery.
6. Safety instructions and disclaimer
Never try to open the device to carry out repairs or modifications. Do not short-
circuit the product. The device is not approved for outdoor use. Therefore please
use it only in dry surroundings. Protect it from high humidity, water and snow. Keep
the product away from high temperatures. Do not expose the device to sudden
changes in temperature or heavy vibrations, as this could damage the electronic
components. Check the device for damage before using it. The product should not
be used if it was subject to impact or has been damaged in some other manner.
Please follow the national regulations and restrictions. Do not use the device for
purposes other than those described in the manual. This product is not a toy.
Keep it out of the reach of children or mentally disabled persons. Any repair or
modification to the device, which is not carried out by the original supplier, will
void the warranty or warranty claims. The device should only be used by those who
have read and understood this manual. The specifications of the product may be
changed without any special prior notification.
10
English