What To Do If The Refrigerator Does Not Work; Technical Specifications - Vitrifrigo DRW Serie Manual De Instalación

10 WHAT TO DO IF THE REFRIGERATOR DOES NOT WORK

Problem Possible cause(s)
The power cable plug has not been properly plugged
The refrigerator/freezer does not
into an electrical socket.
work. The temperature in the
The temperature control has not been set correctly.
refrigerator/freezer is too high.
The refrigerator is positioned next to a heat source
or is exposed to direct sunlight.
There is not enough space between the refrigerator
and the sides/back.
The refrigerator is too full. Food blocks the
ventilation openings.
The temperature control has not been set correctly.
The refrigerator/freezer cools
excessively.
The refrigerator is equipped with thermally
The part of the metal frame
insulated pipes on the front frame that prevent
around the refrigerator is hot
condensation from forming on the door seal when
the drawer is closed
Food has spoilt
There is an unpleasant smell in the
refrigerator
Food has a strong smell
The door was not properly closed.
Frost has formed on the inside
walls.
Food blocks the ventilation openings.
Condensation has formed on the If the drawer is left open, humidity can enter the
inside walls. refrigerator.
Food with high moisture content.
The internal temperature is too high
The refrigerator does not stop
Try running a reset
The courtesy light does not switch
The light is faulty
on
The refrigerator is noisy

11. TECHNICAL SPECIFICATIONS

Parameter
Power Supply
Max Consumption – Normal
operation
Max Consumption during defrost
Climatic Class
Refrigerant
Refrigerant quantity
CO2 equivalent
Global warming potential (GWP)
Weight
IMPORTANT
If an external 12/24Vdc power supply is used, refer to the power values
Solution
Plug the power cable in properly.
Set a lower temperature.
Make sure that the refrigerator is positioned away
from direct sunlight and any heat sources
Make sure that there is at least 2 cm of space
between the back and side walls of the cabinet
Do not overfill the refrigerator. Make sure that food
does not obstruct the ventilation openings
Set a higher temperature
In order to prevent condensation from forming, the
refrigerator is equipped with insulated pipes on the
front frame. This does not mean that there is a
problem or fault in the system
Clean the refrigerator and remove any spoilt food.
Wrap food that has a strong smell in film.
Make sure that food does not prevent the drawer
from being properly closed. Clean the drawer seal
Make sure that food does not obstruct the
ventilation openings
Remove the humidity and do not open the drawer
for a long period of time.
Wrap the food in film.
Check that the drawers close tightly
Disconnect the power cable. Wait for a minute and
then reconnect it. Try switching the unit on again.
Call the service centre
Check that the refrigerator sits flat and is not in
direct contact with any object that might cause
vibrations
Value
12-24 Vdc
100-240Vac / 50-60Hz Dual electronic control
4A at 12Vdc
8A at 24Vdc
**
10,5A a 12Vdc (126W)
**
10,5A a 24Vdc (252W) Modulating PWM
T
R290
0,032 kg DRW180A
0,034 kg DRW70A
< 0,0001 t
3
55 kg DRW180A
38 kg DRW70A
**
increased by 20%.
65
EN