Low Pressure; High Pressure - Craftsman 580.752190 Instrucciones De Uso

Ocultar thumbs Ver también para 580.752190:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun, spray tip extension and quick connect
spray tips. There is also a detachable hose wrap at the back
of the accessory tray to hold your high pressure hose.
1.
Place spray tip extension in clip on back of accessory
tray.
2.
Place spray gun through hole on accessory tray on right
side of unit.
3.
Insert multi–colored spray tips in spaces provided in
accessory tray.
4.
Wrap high pressure hose on hose wrap then attach hose
wrap to back of accessory tray.
5.
Hook provided on back of accessory tray for safely
storing safety goggles.
How to Use Spray Tips
The quick–connect on the spray tip extension allows you to
switch between four different quick connect spray tips. The
spray tips vary the spray pattern as shown below.

High Pressure

40° White
15° Yellow
1750 PSI
2200 PSI
2.3 GPM
2.2 GPM

Low Pressure

Black
Use to apply
chemical
0° Red
2550 PSI
2.0 GPM
Follow these instructions to change spray tips:
1. Pull back collar on quick–connect and pull current spray
tip off. Store spray tips in holder provided on the
accessory tray.
WARNING: The high pressure stream of water that this
equipment produces can cut through skin and
its underlying tissues, leading to serious injury
and possible amputation.
• NEVER exchange spray tips without the trigger locked on the
spray gun.
• DO NOT twist spray tips while spraying.
2. Select desired spray tip:
For delicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV's, patio
furniture, lawn equipment, etc., select white 40°
spray tip.
For general rinsing (medium pressure and medium
flow), ideal for most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc., select yellow
15° spray tip.
For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red 0° spray tip.
To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black detergent spray tip.
3.
Pull back on collar, insert new spray tip and release collar.
Tug on spray tip to make sure it is securely in place.
Usage Tips
For most effective cleaning, keep spray tip from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
If you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
DO NOT get closer than 6 inches (15 cm) when cleaning
tires.
2-IN-1 Soap System
CAUTION: Chemicals can cause bodily injury, and/or
property damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
Cleaning and Applying Detergent with the
Project Pro® PerfectMix™ Siphon
To apply undiluted detergent using the blue
PerfectMix™ siphon, follow these steps:
1. Review use of spray tips.
2. Attach PerfectMix™ siphon hose to
pump and PerfectMix™ concentrate
bottle.
12

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido